From geometric customisation and fitting simulation to topography and wavefront-driven optics, FocalPoints supports different approaches to personalisation within the same manufacturing environment.
Specialty contact lenses are rarely one-size-fits-all. FocalPoints has always been built around the ability to adapt lens designs to individual requirements, combining flexible design tools with structured manufacturing workflows. As technology has evolved, so have the possibilities. Laboratories can move from conventional parameter-based customisation to measured ocular data, virtual fitting and, with enVisus®, wavefront-driven optical correction. The result is not a single personalisation method, but a growing set of tools that laboratories can adopt according to their products, technology and workflow.
One environment. Multiple ways to personalise.
Personalisation is not one feature. It is the progressive use of design parameters, simulation and patient-specific data to make each lens more specific to the individual case, all within the same FocalPoints design environment.
DESIGN FOR THE INDIVIDUAL
Personalisation starts with the lens design itself. FocalPoints Designer provides the tools to modify geometry, zones, diameters and other design parameters according to the requirements of each case. Rather than working from a fixed lens configuration, laboratories can adapt existing designs while maintaining a structured and repeatable manufacturing process. This remains the foundation on which more advanced personalisation can be built.
DESIGN WITH OCULAR DATA
Topography adds another source of information by bringing measured ocular geometry directly into the design process. FocalPoints integrates with supported topographers and diagnostic instruments, allowing laboratories to use patient-specific data when evaluating and adapting lens geometry. This reduces repeated data entry while keeping fitting information connected with the design and manufacturing workflow.
SIMULATE & REFINE THE FIT
Before manufacturing, FocalPoints Designer can help evaluate how the lens is expected to interact with the ocular surface. Interactive fitting simulation and tear-layer visualisation provide additional information for assessing clearance, alignment and other geometric relationships. These tools can support initial design decisions and subsequent modifications without separating fitting analysis from the lens design environment.
USE EXTERNAL FITTING INTELLIGENCE
Personalisation does not need to happen entirely inside FocalPoints. Through integrations such as SimuLENS GATEWAY, laboratories can connect an external virtual-fitting environment with their FocalPoints workflow. Fitting information and lens data can move between systems while FocalPoints remains connected to the downstream design and manufacturing process. This allows laboratories to combine specialised fitting technology with an established production environment.
Beyond geometry.
Personalisation is not only about how a lens fits. With patient-specific optical data, it can also extend to how the lens performs, bringing wavefront-driven correction into the FocalPoints design workflow.
Geometry is only one dimension of personalisation. With enVisus®, FocalPoints extends the concept into wavefront-driven optics. Compatible aberrometry data can be used to calculate a Higher Order Aberration correction for an existing lens design through the enVisus Aberration Correction Engine. This introduces a further form of personalisation: adapting not only how a lens fits, but how its optical performance can be tailored to measured aberration data.
CHOOSE YOUR ROUTE TO PERSONALISATION
There is no single route to personalised lens design. The appropriate approach depends on the data available, the laboratory workflow and how far personalisation needs to extend. These routes are not necessarily sequential. A laboratory may use one or combine several, depending on its products, equipment and workflow.
Technical summary of FocalPoints personalised lens design workflows
Entry Point
Relevant Capability
What It Adds
Prescription
FocalPoints Designer
Customised lens geometry
Topography
Order Entry + Designer
Measurement-guided design and simulation
Virtual Fitting
SimuLENS GATEWAY
Connected fitting-to-production workflow
Wavefront Data
enVisus®
HOA-based optical correction
Not every laboratory needs the same form of personalisation. Some workflows rely primarily on flexible lens geometry. Others incorporate topography, virtual fitting or advanced optical measurements. FocalPoints allows these approaches to coexist within the same design and manufacturing environment, giving laboratories the flexibility to introduce new technologies without rebuilding their workflow around them.
EXPLORE THE RIGHT SETUP FOR YOUR LAB
Every lab works differently. Explore how FocalPoints adapts to your processes and manufacturing goals with the right combination of features and modules.